May 20, 2012, 12:49:48 PM
Pages: [1]

Author Topic: will jackal log air fuel?  (Read 177 times)

mechanix565

  • JACKAL Owner
  • *
  • Posts: 9
    • 93
    • Talon TSI AWD
    • Motor: 4G63 2.0L
    • Head: 1G (large ports)
    • Turbo: big 16g
will jackal log air fuel?
« on: December 18, 2011, 09:35:55 PM »
sorry for the noob question, new to tuning and havnt got my ostrich yet so have yet to see the datalogs.. will jackal log my air fuel ratios off my stock o2 or am i gonna have to watch my wideband to determine when im leaning out? im just trying to learn all of this before i get up nd running.
Logged

slow1g

  • JACKAL Owner
  • *
  • Posts: 103
    • 1991
    • Talon TSI AWD
    • Motor: 4G63 2.0L
    • Head: 1G (large ports)
    • Turbo: GT35R
Re: will jackal log air fuel?
« Reply #1 on: December 18, 2011, 09:57:13 PM »
The wideband will replace your stock o2 sensor and your logs will show the reading from the wideband. 8;)
Logged
Stock 6 bolt, gerrat GT35R with PTE bolt on houseing, 2g manifold, apex n1 full exhaust, fic 1450's, wally 255, punishment fmic,
went 12.4 with 16g at 21 psi

mechanix565

  • JACKAL Owner
  • *
  • Posts: 9
    • 93
    • Talon TSI AWD
    • Motor: 4G63 2.0L
    • Head: 1G (large ports)
    • Turbo: big 16g
Re: will jackal log air fuel?
« Reply #2 on: December 18, 2011, 10:03:06 PM »
sorry im not sure i understand and forgive my ignorance but what i have is an AEM wideband its just a sensor that goes directly to the gauge how is my ecu going to see that information? or do i eliminate the stock o2 sensor and wire in a wideband sensor into the factory harness? then i wouldnt have to run the wideband gauge on the pillar?
Logged

2.3colt

  • JACKAL Owner
  • *
  • Posts: 129
    • 1989
    • Colt
    • Motor: 4G63 2.3L (stroked)
    • Head: 1G (large ports)
    • Turbo: evoIII 16
Re: will jackal log air fuel?
« Reply #3 on: December 18, 2011, 10:20:12 PM »
you remove your o2.. put in the wide band o2 in the stock location.. go inside the car.. locate the ecu. cut the wire coming out of pin 4. (about 6-8 inches away from the plug if u can get that much un taped).. then run the output wire from the wide band gauge to the cut wire on the ecu..

the aem will read the gases.. give u the a/f reading.. and also sends the info to the ecu.

http://forums.ds-map.net/ecu/wideband-and-jackal/

Steve
Logged
Pages: [1]