May 20, 2012, 11:10:26 AM
Pages: [1]

Author Topic: Machine work on head and block and engine break in  (Read 536 times)

Kapok6

  • WEREWOLF Owner
  • *
  • Posts: 283
  • 'ello poppet
    • 1991
    • Talon TSI AWD
    • Motor: 4G63 2.0L
    • Head: 2G (small ports)
    • Turbo: FP3065
Machine work on head and block and engine break in
« on: February 07, 2011, 07:14:07 AM »
Hak, are you able to post the old articles pertaining to the 2g head modifications necessary to put on a 1g block?  Any and all machining article/instructions would be very helpful as well as the thread pertaining to engine break in.
Logged
1991 Eagle Talon TSi AWD-Ross 8:3.1 pistons, Eagle rods, ACL Race bearings, 2g small port head, HKS/Delta 272 cams, Evo springs/retainers, FP3065 @ 28psi (hopefully), FIC 1550's, Apex'i N1 turbo back exhaust, KYB GR-2's on Suspension Technnique springs, megan sturt bars, poly mounts/bushings

hakcenter

  • dev team
  • *
  • Posts: 1047
    • 2006
    • Other
    • Motor: 4G63 2.0L
    • Head: 1G (large ports)
Re: Machine work on head and block and engine break in
« Reply #1 on: February 07, 2011, 10:06:06 AM »
yes when i get back from desert center
Logged
AMP 2 Corinthians 8:21
For we take thought beforehand and aim to be honest and absolutely above suspicion, not only in the sight of the Lord but also in the sight of men.

Kapok6

  • WEREWOLF Owner
  • *
  • Posts: 283
  • 'ello poppet
    • 1991
    • Talon TSI AWD
    • Motor: 4G63 2.0L
    • Head: 2G (small ports)
    • Turbo: FP3065
Re: Machine work on head and block and engine break in
« Reply #2 on: February 07, 2011, 01:27:52 PM »
Good deal.  Thanks Hak.
Logged
1991 Eagle Talon TSi AWD-Ross 8:3.1 pistons, Eagle rods, ACL Race bearings, 2g small port head, HKS/Delta 272 cams, Evo springs/retainers, FP3065 @ 28psi (hopefully), FIC 1550's, Apex'i N1 turbo back exhaust, KYB GR-2's on Suspension Technnique springs, megan sturt bars, poly mounts/bushings

hakcenter

  • dev team
  • *
  • Posts: 1047
    • 2006
    • Other
    • Motor: 4G63 2.0L
    • Head: 1G (large ports)
Re: Machine work on head and block and engine break in
« Reply #3 on: February 07, 2011, 06:27:35 PM »
http://forums.ds-map.net/head-block/2g-head-on-1g-block/

the break-in thread is kinda weird, do you wanna take a look at it ?
Logged
AMP 2 Corinthians 8:21
For we take thought beforehand and aim to be honest and absolutely above suspicion, not only in the sight of the Lord but also in the sight of men.

Pages: [1]