DS-MAP

plx 300m wideband and greddy profec electronic boost controller

boosted brit

  • *
  • 8
    • Talon TSI AWD
    • 1993
    • Head: 1G (large ports)
    • Motor: 4G63 2.0L
    • Turbo: big 16g
plx 300m wideband and greddy profec electronic boost controller
« on: October 13, 2014, 04:06:47 PM »
Im in the process of buying ostrich 2.0 and will be running jackal.
Is there a way to hook up my wideband so that jackal can use it.
And the same with the boost controller?
Im very new to all of this btw.

Re: plx 300m wideband and greddy profec electronic boost controller
« Reply #1 on: October 13, 2014, 09:37:24 PM »
You can control any pwm boost controller through the stock BCS harness. One wire is always power, the other side is to the ECU and the ground is PWM.

You can wire the wideband to the stock o2 wire, please note that #4 is on the left, not right side.
AMP 2 Corinthians 8:21
For we take thought beforehand and aim to be honest and absolutely above suspicion, not only in the sight of the Lord but also in the sight of men.


boosted brit

  • *
  • 8
    • Talon TSI AWD
    • 1993
    • Head: 1G (large ports)
    • Motor: 4G63 2.0L
    • Turbo: big 16g
Re: plx 300m wideband and greddy profec electronic boost controller
« Reply #2 on: October 14, 2014, 06:22:44 AM »
Excuse my lack of knowledge but what is pwm?
And is there a wiring diagram to hook up a bosch (I believe) wideband sensor

Re: plx 300m wideband and greddy profec electronic boost controller
« Reply #3 on: October 14, 2014, 08:21:48 PM »


pwm in a picture.

For the wideband you basically snip the stock o2 narrow band input wire on the ecu, and solder in your 5v out on the wideband of your choice.
AMP 2 Corinthians 8:21
For we take thought beforehand and aim to be honest and absolutely above suspicion, not only in the sight of the Lord but also in the sight of men.


boosted brit

  • *
  • 8
    • Talon TSI AWD
    • 1993
    • Head: 1G (large ports)
    • Motor: 4G63 2.0L
    • Turbo: big 16g
Re: plx 300m wideband and greddy profec electronic boost controller
« Reply #4 on: October 16, 2014, 08:08:13 AM »
thanks I ended up just using the greddy ebc unit, but the info on wideband will be used :)